(4)
Connect the download jig [1] with the jig connector (CN28) on the Finisher control board.
(5)
Take off the rear cover of the equipment.
(6)
Take off the converter PC board from the logic PC board (LGC board)
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
CN28
[ 1 ]
Fig.11-66
Fig.11-67
Fig.11-68
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
11 - 69
FIRMWARE UPDATING
11