Heater Lamp - Toshiba e-STUDIO206L Service Manual

4.13.5

Heater lamp

(1) Take off the separation fingers
( P. 4-113 "4.13.3 Separation finger").
(2) Remove 2 screws of each lamp, and then
take off the center heater lamp, side heater
lamp, sub heater lamp and fuser roller.
Notes:
1. When fixing the screws, do not mix up the
types of screws.
2. When installing the heater lamps, do not
mix up the types of heater lamps.
The shapes and screw holes of each
lamp vary. Install the heater lamps while
referring to the figure at right.
3. Install the heater lamps on their welded
sides on upper.
4. Make sure to connect the white lines to
the center heater lamp and side heater
lamp, and the blue line to the sub heater
lamp.
5. For e-STUDIO206L/256/306 / 207L/257/
307, the sub heater lamp is not installed.
6. Be careful not to deform the fuser roller
by pushing strongly.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Fuser roller
Fig. 4-328
Sub heater lamp
Side heater lamp
Fig. 4-329
Weld
Fig. 4-330
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
4 - 115
White(M4)
Blue
Center
Sub
Side White(M3)
Center heater lamp
DISASSEMBLY AND REPLACEMENT
4