Toshiba e-STUDIO206L Service Manual page 329

(32) Fix the harness with 1 clamp, and then insert
the connector into the hole of the frame of
the equipment.
(33) Attach the harness to the connector of the
switching regulator.
(34) Run the harness through the hole of the
frame of the equipment, and then wire it to
the rear side.
(35) Attach the harness to the clamp.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-540
Fig. 4-541
Fig. 4-542
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
4 - 189
Switching regulator
Clamp
DISASSEMBLY AND REPLACEMENT
4