Toshiba e-STUDIO206L Service Manual page 169

(5) Rotate the drive pulley and move the
carriage-1 so that the screw can be seen.
(6) Take off the rear cover.
 P. 4-3 "4.1.6 Rear cover"
(7) Disconnect the connector of the lamp
harness from the lamp inverter board.
Notes:
Be careful not to apply load to the lamp
inverter board when disconnecting the
connector.
See the following chapter for the installation
procedure.
 P. 4-40 "4.5.9 Installing the lamp harness"
(8) Release 1 clamp of the carriage and take off
the harness wiring on the rear frame.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-84
Fig. 4-85
Clamp
Fig. 4-86
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
4 - 29
Lamp inverter board
DISASSEMBLY AND REPLACEMENT
4