Punching Position Center Adjustment - Toshiba e-STUDIO206L Service Manual

[D] Stapling position adjustment (front 1-point / "R" series size)
This adjustment is performed in the Adjustment Mode (05-4823-3) of the equipment.
Adjustment scale
Adjustable range
Adjustment direction
[E] Stapling position adjustment (center 2-point)
This adjustment is performed in the Adjustment Mode (05-4823-4) of the equipment.
Adjustment scale
Adjustable range
Adjustment direction
[F] Stapling position adjustment (2-point pitch)
This adjustment is performed in the Adjustment Mode (05-4823-5) of the equipment.
Adjustment scale
Adjustable range
Adjustment direction
6.15.5

Punching position center adjustment

This adjustment is performed in the Adjustment Mode (05-4824) of the equipment.
Adjustment scale
Adjustable range
Adjustment direction
6.15.6 Punch hole position adjustment
This adjustment is performed in the Adjustment Mode (05-4825) of the equipment.
Adjustment scale
Adjustable range
Adjustment direction
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
0.2mm
-5.0 mm to 1.0 mm
Increasing the value The distance between the stapling position and the
edge of the paper becomes shorter.
Decreasing the value The distance between the stapling position and the
edge of the paper becomes longer.
0.2mm
-1.0 mm to 1.0 mm
Increasing the value The stapling position moves farther to the front side
from the center position.
Decreasing the value The stapling position moves farther to the rear side
from the center position.
0.2mm
-3.0 mm to 2.4 mm
Increasing the value The pitch between the stapling positions becomes
wider.
Decreasing the value The pitch between the stapling positions becomes
narrower.
0.2mm
-3.0 mm to 3.0 mm
Increasing the value The punching position moves farther to the front
side from the center position.
Decreasing the value The punching position moves farther to the rear
side from the center position.
0.2mm
-4.0 mm to 1.0 mm
Increasing the value The distance between the punch hole and the
trailing edge of the paper becomes shorter.
Decreasing the value The distance between the punch hole and the
trailing edge of the paper becomes longer.
6 - 91
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
SETTING / ADJUSTMENT
6