* a. Do not use alcohol for cleaning the developer unit.
* b. Developer material
After replacing the developer material, be sure to perform the auto-toner adjustment.
P. 6-2 "6.2 Adjustment of Auto-Toner Sensor"
* g. Oil seal
Mixer unit (Shafts of mixers 1, 2 and 3) 6 pcs.
During replacement, coat the oil seal with grease (Alvanian No.2).
(1)
Push in a new oil seal parallel to the
mounting hole section of the developer frame
or outside of the holder.
* Pay attention to the direction in which the
oil seal is attached. (See figure on right.)
(2)
Apply an even coat of grease to the inside of
the oil seal.
•
Amount: About two small drops
(3)
Wipe off any grease the exudes from the
inside.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Inside
Fig. 7-18
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
7 - 25
Developer frame
(Nozzle mixer)
Outside
Grease
Oil seal
PREVENTIVE MAINTENANCE (PM)
7