Firmware Confirmation After The Pc Board/Hdd Replacement - Toshiba e-STUDIO206L Service Manual

9.3.10

Firmware confirmation after the PC board/HDD replacement

After replacing the PC board/HDD, check the firmware version in the setting mode (08) and confirm if
the firmware combination is correct.
Firmware
Updating Master data
(HDD program data)
Updating System ROM
(OS data)
Updating Engine ROM
(Engine firmware)
Updating Scanner ROM
(Scanner firmware)
Updating RADF ROM
(RADF firmware)
Updating Finisher ROM
Updating FAX ROM
The installed ROM versions and the registered optional Electronic License Keys can be confirmed in
the list print mode following the procedure below.
(1) Turn the power ON using the main power switch while pressing the digital key [9] and the
[START] button simultaneously.
(2) Key in "1" three times, and then press the [START] button.
(3) "VERSION LIST" is printed out.
* It is recommended to keep this list for future reinstallation such as the replacement of the SYS
board.
(4) Keep pressing the [ON/OFF] button until you hear a sound to shut down the equipment.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
REPLACEMENT OF HDD/PC BOARDS
Code
08-8952 HD data internal version
08-9900 System software version
08-9930 System ROM version
08-9901 Engine ROM version
08-9902 Scanner ROM version
08-9903 RADF ROM version
08-9904 Finisher ROM version
Saddle stitcher ROM version
08-9944 Hole punch unit ROM version
08-9945 Converter board ROM version
08-9905 FAX ROM version
9 - 38
Remarks
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved