B4-Size Recycled Paper Mode; Normal Mode - Toshiba e-STUDIO206L Service Manual

B4-size recycled paper mode

Step Buttons
1 Button1
2 Button2
3 Button1
4 Button2
Notes:
To change settings from the B4-size recycled paper mode to the normal mode, perform steps (1)
through (4), and then press [Button1] and [Button2] on the control panel as shown below to set
the normal mode.

Normal mode

Step Buttons
1 Button1
2 Button2
3 Button1
4 Button2
(6) When the settings are stored normally, [LED1] on the control panel is lit. [LED1] blinks, if an error
occurs. In this case, turn the power OFF and make the settings again from step (4).
(7) Turn OFF the power of the equipment.
(8) Turn OFF all bits of the SW1 on the Finisher control board.
(9) Install the board access cover.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
SETTING / ADJUSTMENT
Number of pressing
1
1
8
1
Number of pressing
1
1
6
1
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
6 - 100
Remarks
Confirms the input value
Confirms the input value
Remarks
Confirms the input value
Confirms the input value