Toshiba e-STUDIO206L Service Manual page 497

[ 2 ] Folding position adjustment
(1) Turn OFF the power of the equipment.
(2) Remove 2 screws and take off the board access cover [1].
(3) Set the SW1 on the Finisher control board as shown in the figures below.
Turn ON pin 1 and 4.
(4) Turn ON the power of the equipment while [0] button and [8] button are pressed simultaneously.
(5) Press [Button 1] on the touch panel 10 times and then press [Button 2] once. Then press [Button
1] again 2 times, and [Button 2] once again. (Adjustment of LD and A3 paper starts.)
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Fig.6-135
LED3 LED2
Button1 Button2
Fig.6-136
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
6 - 117
[ 1 ]
LED1
SETTING / ADJUSTMENT
6