(7)
Disconnect the connector of the lamp
harness from the lamp inverter board / LED
board.
Notes:
Be careful not to apply load to the lamp
inverter board / LED board when
disconnecting the connector.
See the following chapter for the installation
procedure.
P. 4-40 "4.5.9 Installing the lamp harness"
(8)
Release 1 harness clamp of the carriage and
take off the harness wiring on the rear frame.
(9)
Release the harness from the harness
holder.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-108
Clamp
Fig. 4-109
Fig. 4-110
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
4 - 37
Lamp inverter board
DISASSEMBLY AND REPLACEMENT
4