(3)
Remove 5 screws, disconnect 2 connectors,
and then take off the HDD.
(4)
Remove 4 screws and then remove 2
brackets and the ground wire from the HDD.
9.1.3
LGC board (e-STUDIO206L/256/306)
(1)
Take off the rear cover
( P. 4-3 "4.1.6 Rear cover").
(2)
Disconnect 15 connectors, remove 4 screws,
and then take off the LGC board [1].
Notes:
When replacing the LGC board, remove
IC29 from the old board and then install it on
the new one.
•
When installing EEPROM (IC29)[2], be sure
that its pins are attached in the correct
direction and not misaligned.
•
Do not touch the pins of EEPROM (IC29)[2]
with your bare hands. (Be careful of static
electricity.)
Replace the LGC board following P. 9-28
•
"9.3.5 Procedures when replacing the LGC
board".
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
HDD
Fig. 9-6
Bracket
Bracket
Ground wire
Fig. 9-7
Fig. 9-8
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
REPLACEMENT OF HDD/PC BOARDS
9 - 3
[1]
[2]
9