Precautions And Procedures When Replacing The Sys Board; Return License - Toshiba e-STUDIO206L Service Manual

Multifunctional digital systems

Hide thumbs Also See for e-STUDIO206L:

Table of Contents

Precautions and Procedures when replacing the SYS board

A procedure for SYS board replacement is shown below.

"[D] Restore ADI key" is required only for the equipment in which the ADI-HDD has been

[A] Return License

If the Setting Mode (08) is not started up, "[A]Return License" can be omitted.

In that case, reinstall the license with "[ 1 ]Re-registration when the board is replaced" if it is

cleared since "[G] Reinstallation of License" cannot be performed.

When installing the Data Overwrite Enabler (GP-1070) and security mode is setting High

Security, set the security mode level to "1" (Low level). Then restart the equipment.

Start up with the Setting Mode (08).

Enter the password, and then press the [OK] button.

(If the password is not set for Service, press the [OK] button without entering anything.)

Key in [3840], and then press the [OK] button.

Select the license to be returned, and then press the [REMOVE] button.

Install the one-time dongle, which you used for uploading the selected license, in the equipment,

and then press the [OK] button.

The Remove screen is displayed, then press the [YES] button. If this screen is not displayed,

check whether the one-time dongle is installed in the equipment properly.

e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507

REPLACEMENT OF HDD/PC BOARDS

SATA-HDD: Normal HDD

ADI-HDD: Securely HDD

Show Quick Links

Table of Contents