Recovered Process Unit Mechanism - Toshiba e-STUDIO206L Service Manual

[ 2 ] Recovered process unit mechanism

The process unit of this equipment has two types; one is for the e-STUDIO206L/256/306 / 207L/257/
307 and another is for the e-STUDIO356/456/506 / 357/457/507.
The differences between two are shown below.
Be sure not to install the process unit to a wrong model when replacing them because they are
incompatible each other.
To distinguish them, check the position of the bracket hole seen from the back side.
Parts
Toner recovery roller
Gear, belt
Discharge LED
Needle electrode
Position of bracket hole
(seen from the back side)
e-STUDIO206L/256/306 / 207L/257/307
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO206L/256/306 /
207L/257/307
Not installed
For low speed
10 LEDs
For low speed
Bottom
Discharge LED
Needle
electrode
Toner recovery roller
Fig. 3-50
3 - 69
e-STUDIO356/456/506 /
357/457/507
Installed
For high speed
14 LEDs
For high speed
Top
e-STUDIO356/456/506 / 357/457/507
Gear, Belt
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
OUTLINE OF THE MACHINE
3