When The Paper Is Fed From The Bypass Tray - Toshiba e-STUDIO206L Service Manual

When the paper is fed from the bypass tray:

Proce
Check item
dure
1 ADU
2 Is the 1st transport sensor
working? (Perform the
input check: 03-[FAX]/
OFF/[6]/[A])
3 Is the registration sensor
working? (Perform the
input check in the test
mode: 03-[FAX]ON/[9]/[A])
LGC board
4
5 LGC board, registration
sensor
Parts to be replaced
1st transport sensor
LGC board
Registration sensor
Rollers on the transport path
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Result
Open the ADU and remove paper if there is
any on the transport path.
Yes
No
Yes Check the rollers. Replace them if they are
worn out
No
1. Check if the connector CN316 on the LGC
board is disconnected.
2. Check if the connector pins are
disconnected or the harnesses are open
circuited.
3. Check if the conductor patterns on the LGC
board are short circuited or open circuited.
4. Replace the 1st transport sensor.
5. Replace the LGC board.
1. Check if the connector CN316 on the LGC
board is disconnected.
2. Check if the connector pins are
disconnected or the harnesses are open
circuited.
3. Check if the conductor patterns on the LGC
board are short circuited or open circuited.
4. Replace the registration sensor.
5. Replace the LGC board.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
8 - 55
Measure
Remark
ERROR CODE AND TROUBLESHOOTING
Next
Step
2
3
4
5
8