Fuse - Toshiba e-STUDIO206L Service Manual

3.18.4

Fuse

When the power supply secondary fuse is blown out, confirm that there is no abnormality with each part
using the following table.
[A] e-STUDIO206L/256/306/356/456/506
Voltage Board/Unit
+24VD1 LGC
SLG
Key copy counter / Coin controller
Bridge unit / Job separator / Offset tray
PFP/LCF
+24VD2 MOT/MOT2
Main motor
+24VD3 RADF
+24VD4 Finisher
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
OUTLINE OF THE MACHINE
Part
Process unit fan
Toner motor
Polygonal motor
Upper Tray-up motor
Lower Tray-up motor
TRU fan
Switching regulator cooling fan
Auto-toner sensor
Upper drawer feed clutch
Lower drawer feed clutch
Registration roller clutch
High speed transport clutch
Low speed transport clutch
ADU clutch
Discharge LED
Main power switch
High-voltage transformer
Bypass feed clutch
Scan motor
Exposure lamp (Lamp inverter board / LED board)
ADU motor
Exit motor
Reverse motor (e-STUDIO356/456/506 only)
REV gate solenoid (e-STUDIO356/456/506 only)
3 - 90
F201:8A (Time-lag)
F202:8A (Time-lag)
F203:4A (Time-lag)
F204:5A (Time-lag)
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Fuse type