Toshiba e-STUDIO206L Service Manual page 262

4.13.9 Exit sensor (S9)
(1) Take off the pressure roller unit
( P. 4-112 "4.13.2 Fuser roller unit /
Pressure roller unit").
(2) Remove 1 screw, and then take off the
sensor cover.
(3) Remove the seal [1].
(4) Disconnect 1 connector [2], and then take off
the exit sensor [3] while releasing a hook.
Notes:
Wire the harness as shown in the figure and
fix it with clamp securely.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
DISASSEMBLY AND REPLACEMENT
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 122
Sensor cover
Fig. 4-348
[2]
[3]
[1]
Fig. 4-349
Fig. 4-350