Toshiba e-STUDIO206L Service Manual page 277

(6) Disconnect 1 connector, release the latches
and take off the ADU exit sensor.
4.15.4 ADU motor (M5)
(1) Take off the rear cover.
( P. 4-3 "4.1.6 Rear cover")
(2) Disconnect 1 connector and remove 2
screws, and take off the ADU motor unit.
(3) Loosen 1 screw.
Notes:
When installing the ADU motor, install the
ADU motor unit to the equipment, then close
the Automatic Duplexing Unit before
tightening this screw.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
ADU exit
sensor
Connector
Fig. 4-386
ADU motor unit
Connector
Fig. 4-387
Screw
Fig. 4-388
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
4 - 137
DISASSEMBLY AND REPLACEMENT
4