Restore License; Reinstall License - Toshiba e-STUDIO206L Service Manual

(5) Wait until the restoring of the encryption key is completed. "Operation Complete" is displayed.
(6) Turn the power OFF after the restoring is completed.
If you want to perform the restoring of the license, do not turn the power OFF but perform from
(4) in "[F] Restore license".
[F] Restore license
(1) Turn the power ON while pressing [3] and the [CLEAR] button simultaneously.
(2) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [OK] button without entering anything.)
(3) Key in [5] to select "5. Key Backup Restore", and then press the [START] button.
(4) Key in [3] to select "3. License SRAM to FROM", and then press the [START] button.
(5) Wait until the restoring of the license is completed. "Operation Complete" is displayed.
(6) After the restoring is completed, check that "OK" is indicated in "SRAM License STATUS" and
"FROM License Status". Then, turn the power OFF.
(7) If "4. License FROM to SRAM" is performed by mistake, carry out the following procedure.
 P. 9-39 "[ 1 ] Re-registration when the board is replaced"
[G] Reinstall license
If the license was returned in "[A]Return License", reinstall it with the following procedure.
(1) Turn the power ON while pressing [0] and [8] simultaneously.
(2) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [OK] button without entering anything.)
(3) Key in [3840], and then press the [START] button.
(4) Press the [INSTALL] button.
(5) Install the one-time dongle in the equipment (the one which you used for returning the selected
license before replacing the equipment). Then press the [OK] button.
(6) Select the license to be installed, and then press the [INSTALL] button.
(7) The screen for notifying that the installation will be started is displayed. Then press the [YES]
button.
(8) After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK] button. If the screen for notifying a failure of the performance is
displayed, quit this operation by pressing the [NO] button. Then check that the one-time dongle is
installed properly in the equipment.
(9) Check that the installed license is displayed on the license list.
Remarks:
If there are any other licenses to be installed, repeat from step (13). If there are no other licenses
to be installed, press the [CLOSE] button, and then turn the power OFF.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
REPLACEMENT OF HDD/PC BOARDS
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
9 - 26