Buffer Tray Guide; Finishing Tray Shaft - Toshiba e-STUDIO206L Service Manual

*m. Buffer tray guide
Apply an adequate amount of white grease (Molykote EM-30L) to the entire buffer tray guide
(inside of the folded section of the plate).
*n. Finishing tray shaft
1. Take off the metal shield plate. If the hole punch unit is installed, take it off beforehand.
2. Apply oil as follows through the opening which shows up when the metal shield plate has been
removed.
Apply an adequate amount of white grease (Molykote EM-30L) to the gear teeth of the rack and
pinion gears which drive the aligning plate, and the entire finishing tray shaft.
Pinion gear
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved

Buffer tray guide

Fig. 7-36
Rack gear
Fig. 7-37
7 - 39

Finishing tray shaft

e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
PREVENTIVE MAINTENANCE (PM)
7