Toshiba e-STUDIO206L Service Manual page 242

4.12.4 Filling developer unit with developer material
(1) Install the developer nozzle jig on the
developer bottle.
(2) Rotate the gear on the rear side of the
developer unit to the direction of the arrow
while filling the developer unit with the
developer material. Spread out the developer
material over the developer sleeve.
4.12.5 EPU memory board (EPU)
(1) Remove the developer material
( P. 4-101 "4.12.3 Removing developer
material").
(2) Place the developer unit upside down.
Disconnect 2 connectors.
(3) Remove 1 screw. Then take off the EPU
memory board.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
DISASSEMBLY AND REPLACEMENT
Lid
EPU memory board
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 102
Fig. 4-289
Fig. 4-290
EPU memory board
Fig. 4-291