Toshiba e-STUDIO206L Service Manual page 986

Notes:
• The display of items on this screen varies depending on the types of data written on the USB
media. Each item is displayed only when each data file is written on the USB media in the
following conditions.
Item
1. SYSTEM
FIRMWARE(OS Data)
2. SYSTEM
SOFTWARE (HD Data)
• If the USB media are not recognized properly, "USB device Not detected" message is displayed.
In this case, disconnect the USB media and connect again within 3 minutes, or shut down the
equipment and connect the device properly. Then repeat the procedure from (4).
• If any of the error messages below is displayed, confirm if the data file in the USB media is
correct. Then repeat the procedure from (4).
Error
number
01 Error Loadmodule
02 Machine Model Get Error
03 Copy Data with valid signature in USB
Storage
04 Other models ROMDATA TXXXXXXXX
* The version name comes at "xxxx.xxx.x".
05 Copy Signature File in USB Storage
06 Patch and Normal package in one folder of
USB Storage
(6) Select the item with the digital keys.
"*" is displayed next to the selected item. Display or delete the "*" by pressing the number of the
item.
Item
1. SYSTEM FIRMWARE(OS Data)
2. SYSTEM SOFTWARE (HD Data)
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
FIRMWARE UPDATING
e-STUDIO206L/256/306/356/
456/506
T160SFPWxxxx.tar is written.
(xxxx is version.)
T160HDPWxxxx.tar is written.
(xxxx is version.)
Error message
Updating OS Data
Updating Master data
11 - 30
Condition
e-STUDIO207L/257/307/357/
457/507
T330SFPWxxxx.tar is written.
(xxxx is version.)
T330HDPWxxxx.tar is written.
(xxxx is version.)
Cause
Module loading failed.
Model information was not
downloaded.
Checking of data file failed.
Master data of other model are
stored.
Data files are not stored in the USB
media.
When both the system and patch
update packages are in the USB
media
Remarks
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved