Fuser Unit - Toshiba e-STUDIO206L Service Manual

3.15 FUSER UNIT

3.15.1 General Description
In the fuser unit, toner is fused by applying heat and pressure on the transferred image on the
transported paper. The paper is then transported to the paper exit section after completion of fusing.
The fuser unit consists of the heater lamps, fuser roller, pressure roller, separation fingers, thermistors,
thermostat, etc.
Thermostat
Center
heater lamp
Side
heater lamp
Thermistor
Thermostat
[ e-STUDIO206L/256/306 / 207L/257/307 ]
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Thermostat
Paper exit section
Separation finger
Center
Fuser roller
heater lamp
Exit sensor
Sub
heater lamp
Pressure roller
Side heater lamp
Thermistor
Thermostat
Fuser unit
Entrance guide
Fig. 3-52
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
3 - 71
Paper exit section
[ e-STUDIO356/456/506 / 357/457/507 ]
OUTLINE OF THE MACHINE
Reverse section
Separation finger
Fuser roller
Exit sensor
Pressure
roller
3