[EF12] Saddle Stitch Finisher stapling error (rear)
MJ-1106/1108
Classification
Finisher jam (Saddle section)
Check item
Finisher
Saddle staple cartridge (rear side)
Rear saddle stapler drive unit
Saddle controller board
Replace parts
Rear saddle stapler drive unit
Saddle controller board
[EF13] Saddle stitch unit paper holding home position detection error
MJ-1106/1108
Classification
Finisher jam (Saddle section)
Check item
Finisher
Paper holding home position sensor
(S38)
Saddle controller board
Replace parts
Paper holding home position sensor
(S38)
Saddle controller board
[EF14] Saddle paper exit jam
MJ-1106/1108
Classification
Finisher jam (Saddle section)
Check item
Finisher
Exit sensor (S31)
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
ERROR CODE AND TROUBLESHOOTING
Rear stapling is not correctly done.
•
Is there any paper remaining on the paper transport path
in the Finisher or the equipment, or on the finishing tray?.
•
Is the jam released by taking off the rear staple cartridge
from the Finisher and removing the staple sheet slid from
the staple case?
•
Unit check
•
Connector check
•
Harness check
•
Connector check (CN3)
•
Board check
The paper holder home position cannot be detected.
•
Is there any mechanical problem when the paper holding
cam is rotated?
•
Sensor check
•
Connector check
•
Harness check
•
Connector check (CN8)
•
Board check
Outputting paper is not completed within a fixed time.
•
Is there any paper remaining in the paper transport path of
the equipment or the saddle stitch section of the Finisher?
•
Sensor check
•
Connector check
•
Harness check
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 116
Error item
Measures
Remarks
Error item
Measures
Remarks
Error item
Measures