Toshiba e-STUDIO206L Service Manual page 988

(8) "Patch Update Successful Restart the MFP" is displayed at the bottom of the LCD screen after
the updating is completed properly.
Notes:
• "Update Failed." is displayed at the bottom of the LCD screen when the updating is not
completed properly. "Failed" appears next to the failed item on the status display. Even
though an update fails, do not turn the power OFF until other updates are finished.If "Update
Failed" appears at the bottom of the screen, turn OFF the power and then check the following
items. After confirming and clearing the problems, restart updating from the beginning.
- Do the USB media meet the conditions to be used for updating?
- Is the data file written properly on the USB media?
- Are the USB media installed properly?
- Do the USB media and equipment operate properly?
• When an OS update error or HDD update error occurs, "Update Failed" or "Failed" appears
on the screen and the error number appears next to the message.
For details of each error, refer to the following tables.
Error number
O01 FROM writing failed
O02 FROM verification error
O03 File operation error
O04 SRAM flag set error
O05 Electronic key data backup error
O06 Device error
Error number
H01 File creation error
H02 File decompression error
H03 Partition mount error
H04 Hard disk full error
H00 Other errors
(9) Press the [ON/OFF] button to shut down the equipment, and then remove the USB media.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
FIRMWARE UPDATING
System Firmware Version
Fig.11-24
OS update Error
Error content
HDD update Error
Error content
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
11 - 32