Laser Optical Unit <E-Studio206L/256/306/356/456/506> - Toshiba e-STUDIO206L Service Manual

4.7 LASER OPTICAL UNIT <e-STUDIO206L/256/306/356/456/506>
4.7.1 Laser optical unit
(1) Take off the rear cover.
 P. 4-3 "4.1.6 Rear cover"
(2) Disconnect 2 connectors from the LGC
board.
Notes:
Connect the flat harness to the LGC board
with its electrode side down. An error "CA20"
will be displayed if the connection is
incorrect.
(3) Take off the inner tray.
 P. 4-4 "4.1.9 Inner tray"
(4) Disconnect 1 connector and remove 1 screw.
Take off the duct.
(5) Remove 1 screw and take off the metal plate
cover [1].
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
DISASSEMBLY AND REPLACEMENT
Fig. 4-165
Duct
Fig. 4-166
[1]
Fig. 4-167
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 58
Connector