Adu Opened During Printing - Toshiba e-STUDIO206L Service Manual

[E430] ADU opened during printing
Classification
Cover open jam
Proce
Check item
dure
1 Is the ADU open?
2 Is the ADU opening/
closing switch working?
(Perform the input check
in the test mode: 03-
[FAX]ON/[9]/[F])
3 Replacing board
Parts to be replaced
ADU opening/closing switch
LGC board
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
ADU open jam
Result
Yes Remove the paper if there is any, then close
the ADU.
No
Yes
No • Check if the connector of the ADU opening/
closing switch is disconnected.
• Check if the connector CN311 on the LGC
board is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor patterns on the LGC
board are short circuited or open circuited.
• Replace the ADU opening/closing switch.
• Replace the LGC board.
• Replace the LGC board.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
8 - 69
Error content
Measure
Remark
ERROR CODE AND TROUBLESHOOTING
Next
Step
2
3
8