[E320] Paper fed from the PFP upper drawer not reaching the 2nd transport sensor
[E350] Paper fed from the PFP lower drawer not reaching the 2nd transport sensor
[E3E0] Paper fed from the LCF not reaching the 2nd transport sensor
Classification
Paper transport jam
Proce
Check item
dure
1
Open the side cover. Is
there paper in front of the
2nd transport sensor?
2
Is the 2nd transport sensor
working?
(Perform the input check
in the test mode: 03-
[FAX]OFF/[7]/[A]
3
Is the PFP transport clutch
working? (Perform the
output check in the test
mode: 03-225)
4
Feed roller
Separation roller]
Pickup roller
Transfer roller
Parts to be replaced
2nd transport sensor.
LGC board
PFP transport clutch
PFP board
Feed roller
Separation roller
Pickup roller
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Error content
Jam not reaching the 2nd transport sensor
Result
Yes
Remove the paper.
No
Yes
No
•
Check if the connector of the 2nd transport
sensor is disconnected.
•
Check if the connector CN316 on the LGC
board is disconnected.
•
Check if the connector pins are
disconnected and the harnesses are open
circuited.
•
Check if the conductor pattern on the LGC
board is short circuited or open circuited.
•
Replace the 2nd transport sensor.
•
Replace the LGC board.
Yes
No
•
Check if the connector of the PFP transport
clutch is disconnected.
•
Check if any of the connectors CN241 and
CN244 on the PFP board is disconnected.
•
Check if the connector CN318 on the LGC
board is disconnected.
•
Check if the connector pins are
disconnected and the harnesses are open
circuited.
•
Check if the conductor patterns on the PFP
board and LGC board are short circuited or
open circuited.
•
Replace the PFP transport clutch.
•
Replace the PFP board.
•
Replace the LGC board.
•
Check the condition of the feed roller,
separation roller and pickup roller of each
paper source, and replace them if they are
worn out.
•
Check the transport roller. Replace it if it is
worn out.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
8 - 49
Measure
Remark
ERROR CODE AND TROUBLESHOOTING
Next
Step
2
3
8
4