[Cc80] Front Alignment Motor (M2) Abnormality - Toshiba e-STUDIO206L Service Manual

Check Item
Rear alignment motor (M10)
Replacement part
Rear alignment motor (M10)
Finisher control PC board
MJ-1106/1108
Check Item
Rear alignment plate
Rear alignment motor (M6)
Replacement part
Rear alignment motor (M6)
Finisher control PC board

[CC80] Front alignment motor (M2) abnormality

MJ-1032
Error
Front alignment motor (M2)
Front alignment plate home position
sensor (S5)
Probable cause
Front alignment motor (M2)
abnormality
Front alignment plate home position
sensor (S5) abnormality
Faulty cables and connectors
Finisher control PC board (FIN)
abnormality
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Check the connectors and harnesses between the rear
alignment motor (M10) and the finisher control PC board
(CN10).
If there is mechanical problem when the rear alignment plate is
moved, fix the mechanism.
Check the connectors and harnesses between the rear
alignment motor (M6) and the finisher control PC board (CN17).
Timing of detection
The turning OFF of the front alignment plate home position sensor (S5)
is not detected when the front alignment plate is moved from a point
where this sensor is turned ON to one point where this sensor is turned
OFF after the front alignment motor (M2) has been driven at the
specified number of pulse.
The turning ON of the front alignment plate home position
sensor (S5) is not detected when the front alignment plate is
moved from a point where this sensor is turned OFF to one
point where this sensor is turned ON after the front alignment
motor (M2) has been driven at the specified number of pulse.
Checking and measures
Check if the electrical continuity of the coil is normal. If electricity is not
conducted, replace the motor.
Measure the voltage on TP15 on the finisher control PC board (FIN).
Then check that the measured voltage is 1V or lower when not
shielded and within the range of 3.3V
does not fall within the range mentioned, replace the sensor.
Check if the electrical continuity between the connector terminals is
normal. If electricity is not conducted, replace the connectors. (Finisher
control PC board (FIN): CN5, CN12)
If the error still occurs after replacing the motor, sensor and
connectors, exchange the finisher control PC board (FIN).
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
8 - 187
Measure
Measure
Measure
Measure

5% when shielded. If the voltage
ERROR CODE AND TROUBLESHOOTING
8