Remote Service; Auto Supply Order; If Order Failure Occurs; Order Intervals - Toshiba e-STUDIO206L Service Manual

10. REMOTE SERVICE

There are following functions as Remote Service.

1. Auto Supply Order

Automatically orders the toner by FAX or E-mail.
2. Service Notification
Notifies the status of the equipment to the service technician by E-mail or FAX.
To start in the self-diagnosis mode, turn OFF the power using the main power switch, then turn ON the
power while two digital keys designated to each mode.
10.1 Auto Supply Order
10.1.1 Outline
Automatically orders the toner.
1. Placing an Order
There are two ways to place an order.
- FAX
Installation of the FAX board is required.
If the FAX board has not been installed, it is regarded as OFF setting.
- E-mail (E-mail body + TIFF image)

2. Order Intervals

The Auto Supply Order is sent as indicated in the following steps.
(1) Toner empty occurs.
(2) The toner cartridge is replaced.
(3) The toner empty counter is incremented when the total number of prints or the pixel counter
value exceeds the threshold set in the following self-diagnostic code.
Code
08-6506 Toner empty determination counter
08-6507 Threshold setting for toner empty
determination (output pages)
08-6508 Threshold setting for toner empty
determination (pixel counter)
e.g.) When "0" is set for 08-6506 and "50" is set for 08-6507
The toner empty counter is incremented when 50 sheets are printed after the toner cartridge has
been replaced.
(4) When the accumulated number of toner empty times reaches the set condition, an order is
placed automatically.

3. If Order Failure Occurs

If some problems occur and the order cannot be placed after registering an order as a job, refer to
the standard countermeasure for the FAX/E-mail transmission failure.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Details
Selects the counter to determine toner empty.
0: Output pages
1: Pixel counter
Sets the number of output pages to determine toner
empty. This setting is valid when "0" is set at 08-6506.
Sets the number of the pixel counter value to determine
toner empty. This setting is valid when "1" is set at 08-
6506.
10 - 1
Contents
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
REMOTE SERVICE
10