Converter Firmware (Mj-1101) - Toshiba e-STUDIO206L Service Manual

11.5.11 Converter Firmware (MJ-1101)

The harness jig for board connection is required for updating the firmware of the converter PC board of
the finisher (MJ-1101) as well as the download jig (K-PWA-DLM-320).
Name of the jig
Harness jig for board connection
Important:
• Be sure to connect the equipment and finisher (MJ-1101) before updating the converter
firmware.
• Be sure to shut down the equipment before installing and removing the download jig.
• Do not shut down the equipment during the update. The data could be damaged and not be
operated properly.
[A] Update Procedure
(1) Install the ROM to the download jig (K-PWA-DLM-320).
Make sure the direction is correct.
(2) Press the [ON/OFF] button on the control panel to shut down the equipment and turn the power
OFF using the main power switch.
(3) Take off the finisher board access cover.
(4) Take off the rear cover of the equipment.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Board access cover
Fig.11-59
Fig.11-60
11 - 65
Model name
HRNS-CNV-DL-JIG
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
FIRMWARE UPDATING
11