Toshiba e-STUDIO206L Service Manual page 270

4.14.7 Reverse gate solenoid (SOL1) (only installed for e-STUDIO356/
456/506 / 357/457/507)
(1) Take off the reverse unit.
( P. 4-124 "4.14.1 Reverse unit (only
installed for e-STUDIO356/456/506 / 357/
457/507)")
(2) Remove 3 screws and take off the plate.
Notes:
When installing, engage the slit of the
reverse gate solenoid and the lever of the
gate.
(3) Release the harness from the harness
clamp.
(4) Disconnect 1 connector and remove 2
screws, and take off the reverse gate
solenoid.
Notes:
When installing the solenoid, check if the
solenoid is installed at the center of the
scale. (The scale is longer in the center.).
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
DISASSEMBLY AND REPLACEMENT
Plate
Reverse gate solenoid
Harness clamp
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 130
Reverse unit
Lever
Slit
Fig. 4-369
Connector
Fig. 4-370
Window
Center
Reverse gate solenoid
Fig. 4-371