Saddle Stitch Alignment Position Adjustment; Gripper Arm Exiting Position Adjustment - Toshiba e-STUDIO206L Service Manual

6.15.7

Saddle stitch alignment position adjustment

This adjustment is performed in the Adjustment Mode (05-4826) of the equipment.
Adjustment scale
Adjustable range
Adjustment direction
6.15.8

Gripper arm exiting position adjustment

This adjustment is performed in the Adjustment Mode (05-4827) of the equipment.
Adjustment scale
Adjustable range
Adjustment direction
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
SETTING / ADJUSTMENT
0.2mm
-3.0 mm to 3.0 mm
Increasing the value The alignment plate moves to the center.
Decreasing the value The alignment plate moves to the edge of paper.
0.2mm
-3.0 mm to 3.0 mm
Increasing the value The gripper arm exiting position moves farther to
the front side.
Decreasing the value The gripper arm exiting position moves farther to
the rear side.
6 - 92
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved