11.5.3
Finisher firmware (MJ-1032)
(1)
Install the ROM [2] in the download jig (K-PWA-DLM-320) [1].
Make sure that the type of the ROM and installation direction are correct.
(2)
Turn OFF the power of the equipment. Then slide the Finisher and pull it out from the equipment.
(3)
Remove 1 screw [6] and take off the download cover [7].
[6]
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
FIRMWARE UPDATING
[7]
Fig.11-41
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
11 - 50