Exit Roller - Toshiba e-STUDIO206L Service Manual

4.14.4 Offset gate home position sensor (S24)
(1) Take off the paper exit unit.
( P. 4-125 "4.14.2 Paper exit unit")
(2) Disconnect 1 connector, release the latch
and take off the offset gate home position
sensor.
4.14.5

Exit roller

(1) Take off the paper exit unit.
( P. 4-125 "4.14.2 Paper exit unit")
(2) Remove 2 screws and take off the duct.
(3) Release the harness from the harness
clamp.
Remove 1 screw and take off the motor
cover.
Notes:
When installing the motor cover, engage the
shaft of the motor cover and the bearing of
the gear.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Offset gate
home position
sensor
Connector
Fig. 4-362
Fig. 4-363
Gear
Fig. 4-364
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
4 - 127
Duct
Harness clamp
Motor cover
DISASSEMBLY AND REPLACEMENT
4