Toshiba e-STUDIO206L Service Manual page 1026

(7) Connect the 10-pin side of the harness jig for board connection (HRNS-CNV-DL-JIG) to the
connector (CN2) of the converter PC board [1].
(8) Connect the 15-pin side of the harness jig for board connection to the connector (CN4) of the IF
board.
Notes:
• Be sure to release the connection cable from the connector (CN4) of the IF board when the
hole punch unit (MJ-6103) has been installed.
• Be careful not to short-circuit any part of the converter PC board.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
FIRMWARE UPDATING
Fig.11-69
CN4
Fig.11-70
[1]
CN2
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
11 - 70