(3)
Loosen the hinge screws at the front side.
(4)
Position the pins with the holes on the RADF
by moving it so that the pins fit into the holes
when the RADF is closed.
(5)
Tighten the left-hand hinge screw at the rear
side.
(6)
Loosen the hole position adjustment screws
on the right hand side. (MR-3021/3022)
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
SETTING / ADJUSTMENT
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
6 - 72
Fig.6-74
Fig.6-75
Fig.6-76
Fig.6-77