When The Paper Is Fed From The Lower Drawer; When The Paper Is Fed From The Pfp Or Lcf - Toshiba e-STUDIO206L Service Manual

When the paper is fed from the lower drawer:

Proce
Check item
dure
1 ADU
2 Is the registration sensor
working? (Perform the
input check: 03-[FAX]/ON/
[9]/[A])
3 LGC board, registration
sensor
Parts to be replaced
Registration sensor
LGC board
Rollers on the transport path

When the paper is fed from the PFP or LCF

Proce
Check item
dure
1 Feed cover
2 Is the 2nd transport sensor
working? (Perform the
input check: 03-[FAX]/
OFF/[7]/[A])
3 LGC board, 2nd transport
sensor
Parts to be replaced
LGC board
2nd transport sensor
Rollers on the transport path
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
ERROR CODE AND TROUBLESHOOTING
Result
Open the ADU and remove paper if there is
any on the transport path.
Yes Check the rollers. Replace them if they are
worn out
No
1. Check if the connector CN316 on the LGC
board is disconnected.
2. Check if the connector pins are
disconnected or the harnesses are open
circuited.
3. Check if the conductor patterns on the LGC
board are short circuited or open circuited.
4. Replace the registration sensor.
5. Replace the LGC board.
Result
Open the feed cover and remove paper if there
is any on the transport path.
Yes Check the rollers. Replace them if they are
worn out
No
1. Check if the connector CN316 on the LGC
board is disconnected.
2. Check if the connector pins are
disconnected or the harnesses are open
circuited.
3. Check if the conductor patterns on the LGC
board are short circuited or open circuited.
4. Replace the 2nd transport sensor.
5. Replace the LGC board.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 56
Measure
Remark
Measure
Remark
Next
Step
2
3
Next
Step
2
3