Toshiba e-STUDIO206L Service Manual page 251

4.13 FUSER UNIT
Notes:
Be sure to turn the power OFF and unplug the power cable during service.
4.13.1 Fuser unit
(1) Open the small right rear cover.
(2) Loosen 2 screws and take off the fuser unit.
Notes:
Be careful when handling the fuser unit as it
may become very hot.
Notes:
To store the removed fuser unit for a long
period, follow the procedure below.
(1) Open the front cover.
(2) Take off the pressure release metal plate
(front) [1] from the front cover.
(3) Take off the pressure release metal plate
(rear) [2] from the front cover.
(4) Lower the pressure release levers in the
fuser unit to release them.
(5) Install the metal plates removed in step (2) in
the fuser unit with 1 screw each.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-318
Fig. 4-319
[1]
Front side
Fig. 4-320
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
4 - 111
Small right
rear cover
Fuser unit
[1] [2]
[2]
Rear side
DISASSEMBLY AND REPLACEMENT
4