Adjustment Of Image Density - Toshiba e-STUDIO206L Service Manual

6.7.2

Adjustment of image density

The image density level can be set at the following codes.
Code
7595-0 to 4 Adjustment of image density
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in the code and press the [START] button.
(3) Key in the sub code and press the [START] button.
(4) Key in an adjustment value.
(To correct the keyed-in value, press the [CLEAR] button.)
(5) Press the [OK] or [INTERRUPT] button to store the value in memory. The equipment goes back
to the ready state.
(6) For resetting the value, repeat step (2) to (5).
(7) Turn the power OFF.
<Confirmation>
Check the beam level conversion setting with the actual fax data received, if possible.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
SETTING / ADJUSTMENT
Item to be adjusted
6 - 44
< Adjustment Mode (05) >
Remarks
When the value is decreased, text becomes lighter.
Acceptable values: 0 to 10
Notes:
1. Set not to reverse the large and small
number of the setting value corresponding
to the sub code.
Ex.) When the image density level for 7595-
0, 7595-1, 7595-2, 7595-3, and 7595-4 is
assumed to be "A", "B", "C", "D", and "E"
respectively, they should have the following
correlation:
2.
A B C D
Remember that the image specifications
and life span of the replacing parts may not
meet the standard when the setting value is
changed from the default value.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
E