[E190] LCF misfeeding (paper not reaching the LCF feed sensor)
Classification
Paper misfeeding
Proce
Check item
dure
1
Open the LCF side cover.
Is there any paper in front
of the LCF feed sensor?
2
Is the LCF feed sensor
working?
(Perform the input check
in the test mode: 03-
[FAX]OFF/[4]/[C])
3
Is the LCF feed clutch
working? (Perform the
output check in the test
mode: 03-209)
4
LCF feed roller
Separation roller
Pickup roller
Parts to be replaced
LCF feed sensor
LCF board
LGC board
LCF feed clutch
LCF feed roller
Separation roller
Pickup roller
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
ERROR CODE AND TROUBLESHOOTING
Jam not reaching the LCF feed sensor
Result
Yes
Remove the paper.
No
Yes
No
•
Check if the connector of the LCF feed
sensor is disconnected.
•
Check if either of the connectors CN1 or
CN7 on the LCF board is disconnected.
•
Check if the connector CN318 on the LGC
board is disconnected.
•
Check if the connector pins are
disconnected and the harnesses are open
circuited.
•
Check if the conductor patterns on the LCF
board and LGC board are short circuited or
open circuited.
•
Replace the LCF feed sensor.
•
Replace the LCF board.
•
Replace the LGC board.
Yes
No
•
Check if the connector of the LCF feed
clutch is disconnected.
•
Check if any of the connectors CN1 and
CN6 on the LCF board is disconnected.
•
Check if the connector CN318 on the LGC
board is disconnected.
•
Check if the connector pins are
disconnected and the harnesses are open
circuited.
•
Check if the conductor patterns on the LCF
board and LGC board are short circuited or
open circuited.
•
Replace the LCF feed clutch.
•
Replace the LCF board.
•
Replace the LGC board.
•
Check the LCF feed roller, separation roller
and pickup roller.
Replace them if they are worn out.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 66
Error content
Measure
Remark
Next
Step
2
3
4