7.8.5
Checking and replacing the transfer roller
1. Handling precautions
-
Wear gloves to avoid touching the drum surface with your bare hands.
-
Do not allow oil or fingerprints to come in contact with the surface.
-
Do not hit or scratch the surface.
-
Make sure you do not get any bits of thread, etc. on the surface.
-
Do not allow solvent, such as thinner, to come in contact with the surface.
-
Keep away from a source of heat.
2. Cleaning procedure
If bits of thread or similar adhere to the surface, remove them with gloves or a pair of tweezers. Be
careful that the roller surface is not damaged by the points of the tweezers.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
7 - 49
PREVENTIVE MAINTENANCE (PM)
7