Control Panel Cover - Toshiba e-STUDIO206L Service Manual

4.3.6

Control panel cover

(1) Release the 4 latches [1], and take off the
control panel cover [2].
4.4 CONTROL PANEL <e-STUDIO207L/257/307/357/457/507>
4.4.1 Control panel unit
(1) Take off the rear cover.
 P. 4-12 "4.2.6 Rear cover"
(2) Disconnect 1 connector [1] from the SYS
board (CN119), release the harness from 1
harness clamp [5], and then insert this and
the harness into the hole [2] of the frame.
(3) Remove the front upper cover.
 P. 4-10 "4.2.2 Front upper cover"
(4) Lower the control panel unit [3] and remove 2
screws.
(5) Remove the control panel unit [3] while
sliding it toward the rear side.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
DISASSEMBLY AND REPLACEMENT
[ 1 ]
[5]
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 22
[ 2 ]
[ 1 ]
Fig. 4-63
Fig. 4-64
Fig. 4-65