Carriage Wire / Carriage-2 - Toshiba e-STUDIO206L Service Manual

4.5.11

Carriage wire / carriage-2

(1) Take off the carriage-1.
 P. 4-36 "4.5.7 Carriage-1"
(2) Attach the wire holder jigs to the pulleys to
prevent the wires from loosening.
Notes:
Refer to the following procedure for the
direction of the wire holder jigs.
Service Handbook Chap.3
(3) Detach the tension springs of the front and
rear sides.
(4) Remove the carriage wires.
(5) Take off carriage-2 by rotating it as shown in
the figure on the right without touching the
mirrors.
Notes:
1. When replacing the mirrors-2 and -3,
replace the carriage-2 together with
mirrors-2 and -3. Mirrors-2 and -3 should
not be removed.
2. When installing carriage-2, fix the bracket
temporarily at the position (A). Then
move it to the direction (B), push it to the
end and fix securely.
 P. 4-38 "Fig. 4-113 "
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-125
Carriage wire
Tension spring
Tension spring
Fig. 4-126
Fig. 4-127
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
4 - 43
Carriage wire
DISASSEMBLY AND REPLACEMENT
4