Parts to be replaced
SYS board
[F200] Data Overwrite option (GP-1070) disabled
Classification
Other service call
Check Item
Setting
[F500] HD partition damage
Classification
Other service call
Check item
Setting
[F510] Application start error
Classification
Other service call
Check item
Setting
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
ERROR CODE AND TROUBLESHOOTING
Data Overwrite option (GP-1070) disabled
Perform firmware installation (all firmware: OS, HDD, SYS,
PFC Firmware, Engine Main Firmware, and Scanner
Firmware) with the USB media.
* When the function of the Data Overwrite option (GP-
1070) is deleted from the equipment, the service call
"F200" occurs.
Perform 08-3840 to install the Data Overwrite Enabler (GP-
1070).
* If F200 occurs while High ("3") is set for the security
level (08-8911), it cannot be released by installing the
firmware using the USB media. Install the Data
Overwrite Enabler (GP-1070) by 08-3840.
The file system is abnormal.
Diagnose the file system with [5] + [C] + [Start] 1. Check
•
F/S, and then recover the problem partition with [5] + [C] +
[Start] 2. Recovery F/S.
•
If it still is not recovered by performing the above, reinstall
the software after formatting the HDD with [3] + [C] +
[START] -> 3: Format HDD.
The application fails to start.
1. Reboot.
2. If it has still not recovered, reinstall the HDD software.
3. If it still persists after step 2, perform [3] + [C] + [Start] -> 3,
and then reinstall the HDD software.
Note: User data will be deleted when [3] + [C] + [Start] -> 3 is
performed.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 214
Remark
Contents
Measure
Error item
Measures
Error item
Measures