Toshiba e-STUDIO206L Service Manual page 1015

(5) Remove 3 screws and take off the rear cover of the hole punch unit.
(6) Connect the download jig with the jig connector (CN9) on the finisher control PC board.
(7) Set the DIP-SW4 on the hole punch control PC board to ON.
(8) Turn the power ON using the main power switch while simultaneously holding down the [0] and
[8] buttons.
Updating starts and the LED on the download jig lights.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Rear cover
Fig.11-53
Download jig
Fig.11-54
ON
1 2 3 4
Fig.11-55
11 - 59
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
FIRMWARE UPDATING
11