Toshiba e-STUDIO206L Service Manual page 263

4.13.10 Installation of the fuser unit fuse (service part)
(1) Take off the fuser unit
( P. 4-111 "4.13.1 Fuser unit").
(2) Remove 1 screw and take off the rear cover
[1].
(3) Disconnect 1 connector [2].
Notes:
• When installing the rear cover [1], make
sure that the harness is not caught.
• Install the rear cover [1] with the ground
leaf spring [3] outside of it as shown in the
right-hand figure.
(4) Connect the connectors of the fuser unit
fuse.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
[2]
Fig. 4-351
Connector
Fig. 4-352
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
4 - 123
[1]
[3] [3]
Fuser unit fuse
DISASSEMBLY AND REPLACEMENT
4