Saddle Stitcher Firmware (Mj-1106) - Toshiba e-STUDIO206L Service Manual

11.5.13 Saddle stitcher firmware (MJ-1106)

[A] Update Procedure
(1) Install the ROM to the download jig.
Make sure the direction is correct.
(2) Turn OFF the power of the equipment.
(3) Open the front upper cover and then pull out the saddle stitch unit.
(4) Loosen 2 screws and open the saddle control PC board access cover [1].
(5) Connect the download jig [1] with the jig connector (CN16) on the Saddle control board.
(6) Turn ON the power while pressing [0] and [8] simultaneously.
Updating starts and the LED on the download jig [1] lights.
(7) When the update completes normally, the LED on the download jig [1] starts blinking.
The LED on the download jig starts blinking in approx. 8 seconds after the update started.
It is assumed that the update is failed if the LED does not start blinking even after 15 seconds
have elapsed.
In this case, turn the power OFF and check the following items.
Then, clear the problem and restart updating from the beginning.
• Is the downloading jig connected properly?
• Is the ROM attached to the downloading jig properly?
• Have the update data been written correctly to the ROM on the jig?
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
FIRMWARE UPDATING
[ 1 ]
Fig.11-71
[ 1 ]
Fig.11-72
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
11 - 72