Releasing The Stack Tray Guide Lever Fixing Plate - Toshiba e-STUDIO350 Service Handbook

3.12.5

Releasing the stack tray guide lever fixing plate

(1) Remove the right inner cover and the rear cover.
(2) Remove the finisher control PC board, PC board bracket and sensor PC board.
(3) Remove the stack tray.
(4) Remove the stack tray drive unit.
(5) Place the stack tray guide lever fixing plate so that it is in view through the hole in the side plate
(front, rear). Then remove the fixing screw. (Perform the same for the front and the rear.)
Note: Note:
When removing the mounting screw, be sure to hold the stack tray guide lever up from below.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Screw
Stack tray guide lever
fixing plate
Fig. 3-126
Stack tray
guide lever
Fig. 3-127
3 - 89
e-STUDIO350/352/353/450/452/453
ADJUSTMENT
3