VLAN Management Commands
show vlan
Displays a list of VLANs and their attributes configured on the switch.
show vlan [vid1 [-vid2]]
Syntax Definitions
vid1
-vid2
Defaults
By default, a list of all VLANs and their attributes are displayed.
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Specify a VLAN ID with this command to display information about a specific VLAN.
•
Note that specifying a range of VLAN IDs is also allowed. Use a hyphen to indicate a contiguous
range (e.g., show vlan 10-15). Note that only one VLAN entry—a single VLAN ID or a range of
VLAN IDs— is allowed with this command. Multiple entries are not accepted.
Examples
-> show vlan
vlan
type
admin
-----+-----+------+-----+----+-----+----+-----+-----+-----+-----+---------
1
std
on
100
vstk
on
-> show vlan 1
Name
Administrative State: enabled,
Operational State
1x1 Spanning Tree State : enabled,
Flat Spanning Tree State : enabled,
Authentication
IP Router Port
IPX Router Port
Mobile Tag
Source Learning
OmniSwitch CLI Reference Guide
The VLAN ID number (2–4094).
The last VLAN ID number in a range of VLANs that you want to
configure (e.g. 10-12 specifies VLANs 10, 11, and 12).
stree
oper
1x1
flat auth
on
on
on
off
off
off
on
off
: VLAN 1,
: enabled,
: disabled,
: off,
: none,
: off,
: enabled
June 2012
mble
src
ip
ipx
tag
lrn
off
NA
off
on
off
NA
off
off
name
VLAN 1
VLAN 100
page 5-15