Hitachi Compute Blade 2000 User Manual page 1024

Hide thumbs Also See for Compute Blade 2000:

Table of Contents

If you type E in the SEC command menu and press Enter, you can set the permissible

network settings for connecting a Telnet server. You can choose to allow or deny all

access, or allow access only from an address range defined by a particular network

address and subnet mask.

When you enter a setting, the new setting and a confirmation message appear. To

save the permissible setting for the network, type Y and press Enter. To cancel the

setting, type N and press Enter, or just press Enter.

(F,S,E,H,A,[Q]) : E

Allow all? (Y,[N]) : N

Deny all? (Y,[N]) : N

Network address :

([Unchange]) :

-- Telnet setting --

Network address : ALL

Confirm? (Y,[N]) : Y

- Writing setting was completed.

Hit enter key.

If you type H in the SEC command menu, and then press Enter, you can set the same

permissible network settings for connecting to all three protocol servers (FTP, SSH,

and Telnet). You can choose to allow or deny all access, or allow access only from an

address range defined by a particular network address and subnet mask.

When you enter a setting, the new setting and confirmation message appear. To save

the permissible setting for three protocols: FTP, SSH, and Telnet, type Y and press

Enter. To cancel the setting, type N and press Enter, or just press Enter.

(F,S,E,H,A,[Q]) : H